smart glass film, PDLC glass film, electric control glass,PDLC Switchable Film
How to make smart glass / Swichable glass
1, glass preparation.
After get the required smart glass size, we make the appropriate size of the glass, and according to the need to decide whether the glass edging and edging forms; smart glass with the film already belong to the safety glass composite, and most of the time Less use of toughened glass saves money and saves time. However, if it is necessary to use toughened glass for transportation or customer needs, it should be possible to control the flatness of the glass during toughening.
2, The size of the film must be smaller than the size of the glass.
Usually each side of the diaphragm is about 2mm smaller than the glass, if the condition of the glass edge can be masked during installation, then it can be a little bigger, but each edge should not exceed 4mm, to avoid the stress effect; if the glass is spliced together, Then 2mm is more appropriate, otherwise it will affect the appearance.
3, Combining the film process.
Switchable glass and other laminated glass and the process is very close, first of all the glass to be one side of the piece clean, and then put a film; check the film for impurities, and impurities removed; the Switchable film protection The film is unfolded, and then the clean Switchable film is placed on the glass on which the film has been placed in good position; another layer of film is placed to check whether the film has impurities and the impurities are removed; and another clean glass , And finally cut out the excess film (if it is tempered glass to be thick film). Please note that in the process, it is necessary to check whether the Switchable film has moved due to your operation. If it is adjusted at any time, the Switchable film can be bent and can be wrapped, but it can not be recovered if there is any damage.
4, according to your plastic processing technology, the whole process of vacuum.
5, After the processing is finished, wait for the glass to cool to room temperature, then stop the vacuum and remove the glass, modify the edge and energize the test.
6, Above all, if you follow these to operate has been able to produce a standard dimming glass, and if you want to improve the product, please contact us.
Customized or wooden case
3~7 days after receiving payment
Lever Industry Co have more than 19 years of experience in the Glass Machine Industry.
We are Unremitting, Just for Customer Satisfication!
|Contact Person :
|Job Title :
||+86 136 5379 2967